I need some help troubleshooting my print issues. A while back (months) I updated the firmware on my Elegoo Neptune 4 Pro. After I did that, I have not been able to get a quality print since. (I’m a teacher and a dad, so I just haven’t had many free moments to sit down and really work on it.) My worst issue is the Z axis on the calibration cube. X and Y are less egregious. Using Elegoo Rapid PLA+ and the same default settings I was using pre-update. Any advice would be helpful.
Also, white color is the worst for troubleshooting, literally any other color would do better. But even from that, I see your overhangs are drooping, suggesting too big temperature, over extrusion or no part cooling. Edit: corners also look overly rounded, so pressure advance is likely very off, too.