I’m incredibly new to 3D printing. I have an Anycubic Photon Mono 2 and I’m using the Anycubic standard resin. My first couple of prints went fine; first one was the test print and the second was a set of dice (which technically didn’t go fine since I wasn’t aware you can’t just print right on the plate, so one side was blank).

However, ever since then my next 4 prints have failed. I thought I was maybe going too complex right off the bat - attempting to print a flexible dragon for my kids - so I decided to run the resin exposure test (“RERF”). Only 4 of the 8 printed, and the ones that did only barely printed. I have absolutely no idea what’s going on with this and was hoping that someone here could give some insight and advice.

Thanks!

  • papalonian@lemmy.worldEnglish
    2·
    21 hours ago

    Double check the settings in your printer and slicer that “screen brightness”, “screen power”, “max power” or something to that effect is set to 100%. I’ve seen some default to 70%-80%, the theoretical reason being that reducing power to the screen can lengthen its lifespan… however, afaik these claims have not been backed up by data, and the logical counterargument is that any lifespan gains will be offset by the increased length of time the screen is on. Even if you can squeeze a few extra prints out of the screen before it dies, you’re making all your prints take way longer than necessary.

    Print settings

    For reference, this is the recommended printing settings chart provided by anycubic for their standard gray resin; the recommended exposure time for your printer at default layer height is 2.5 seconds. If you’re using 100% power, you’re more than doubling the normalexposure.