It’s only $10 shipped for the whole kit from Creality, so I figured why not. I accidently pinched the wiring and had to repair it so that’s why there’s heat shrink on it.
It’s only $10 shipped for the whole kit from Creality, so I figured why not. I accidently pinched the wiring and had to repair it so that’s why there’s heat shrink on it.
So, fun issue those things can have: my Sovol SV07 Plus has one and it works great… or it did until the filament chewed through the plastic and made very awkward channels in and out of it. In itself no big deal, still goes through the sensor, but the issue is that it can be a bit too tight of a fit and get jammed. Like, HARD so you have to try pulling it both ways before it dislodges. It’s not a fun way for a print to fail. My workaround is to use a tiny bit of ptfe tube at the entrance, hot glued there so the filament will go straight. So far it’s been working.