So I have a bambulab A1 and recently wanted to print something with TPU. The issue I have however is that the extrusion is just hella inconsistent. I get a coupel seconds of normal extrusion and then a couple seconds of pretty much none. The first layer was only half filled when I checked and I want to know if you guys have any suggestions.
I used the base preset for generic TPU.
This is the first layer I get after trying a couple different presets. Better than before but still horrible.
turn off dynamic flow calibration, and print slower. Don’t use AMS, you have to use the external spool holder.
I never used dynamic flow calibration and don’t have an AMS. Should I just reduce the default preset speed then?