So I have a bambulab A1 and recently wanted to print something with TPU. The issue I have however is that the extrusion is just hella inconsistent. I get a coupel seconds of normal extrusion and then a couple seconds of pretty much none. The first layer was only half filled when I checked and I want to know if you guys have any suggestions.
I used the base preset for generic TPU.
This is the first layer I get after trying a couple different presets. Better than before but still horrible.
I would assume so, worst that can happen is a failed print
Which is what happens anyway since it’s not extruding right.
Exactly, what specific fillament are you having trouble with out of curiosity?
TPU 85A from Azurefilm. I don’t thibk they sell it anymore though.