That’s good to know thanks!

Good to know, I’ll have to play with it.

Ah that makes sense haha

Hmmm, that doesn’t sound very encouraging haha. Well I’m gonna try PEI anyway, see if I can keep it flat enough.

That’s encouraging!

I thought too cold caused warping, does too warm cause it as well?

Now I know this to be true

I put the whole apparatus in the fridge for a few hours, hoping it would just pop off.

The edges came up clean, but the very middle was very unhappy. I had some lifting on the corners so I think there was a draft and the plate wasn’t warming equally. Hot spot in the middle trying to keep up maybe? IDK.

This is a pretty deep hole, I don’t think tape will cut it.

But I’ve been printing little things on the front portion 🤷‍♂️

I do this too, normally it works a treat.

Somehow I missed all the warning signs and discussion on the subject. I’ll never forget.

Can’t be much worse than a big hunk of glass?

Awesome! I ordered one, I’ll give it a try

Nice! Yeah I’ve loved this glass. I might go back to it, but I’m gonna try PEI for awhile 🤷‍♂️

I googled it, you put down a magnetic sheet first. Sweet, I ordered one

I’ve definitely done that!

I meant PLA sorry

Nice! Could you link it? Very curious.

Also how does it do with PETG? Apparently PEI/PEO doesn’t do so well?

How do you keep the plate flat to the bed without magnetics?

That’s my fault for jumping in without researching lol.

Now I see why PETG isn’t as popular.

I needed something with more heat resistance than ABS but I didn’t want to go through the work of making an enclosure