Superb

When did you design this? I remember printing a very similar phone stand years ago. I used it for a long time, it was great!

NixOS is great if you’re ready to learn Nix, which is an undertaking

After watching the video I’m not certain what it could be, but I’ve heard similar before from my printer so I’ll list them in order of sound similarity:

• My X belt wasn’t fully aligned in its track and it was rubbing on the side, which caused a similar clicked noise when any X move occurred.
• When there too much pressure in the hot end (from a clog, low temp, or too close to the bed, etc), I’ve seen the filament “kicking back” out of the extruder. Watch for a sudden backwards jerk of the filament.
• My X stepper motor made some terrible noises after tightening the associated belt. I’m not sure what’s causing it exactly, but I’m replacing the stepper soon.

I’ve just started my switch to PETG and I don’t think I’m going back!

Sure, but I need to tell them what I want on it. I still have to make all the little decisions involved in making sandwich instead of just picking something off a menu. Even if I pick something off the menu they still ask me about every little thing

One of the reasons I hate subway

One of the many internal contradictions that my mental illnesses have blessed me with

I think you’re overthinking it, also the tweets are in the wrong order chronologically in your story. The smaller tweet happened first