No idea what the deal is here.
This is on my slightly modded Creality Ender 3 Pro. (It’s got a CR-Touch, better springs, a metal extruder assembly, an upgraded official Ender 3 Pro motherboard with quieter stepper controller capability. Nothing all that invasive.) Identical gcode worked perfectly fine on my Ender 3 V2 Neo. (Which is sufficiently similar that gcode is interchangeable.) I’ve used that particular roll of filament for other prints before and had no issues. And the same printer has given me no other similar issues with other prints, including prints that were taller than where it failed on these photographed prints.
After the one on the right failed, I assumed it was a clog and did a cold pull. The second print (still on the bed) started out just fine, but started underextruding the same way at almost exactly the same place. I say “almost” because looking closely in person, it does look like the second started underextruding just maybe 3 to 4 layers later than the first.
I suppose it’s possible it was a second clog at almost exactly the same place on the second print, but it’s pretty coincidental if so. Plus recovering spontaneously on that second print is pretty weird.
I dunno. Just very weird and I’m hoping folks here have an idea what I might look into to find a solution. Thanks in advance!
Also, just a few more images in case it helps:
Either your slicer is failing: try shifting the object a little or rotating it and slicing it again.
Or your Z axis has something happening at that spot. Try cleaning and lubing it and see what happens when you jog through that spot a couple times.
I had a case that looked like that, because the nozzle was scraping the previous layer of the print.
I think that for some reason the layers below were physically taller than in softwas and the additive effect of that stacked and reached critical failure at a certain height. It started as soft scraping and got worse as it went on until it failed like that because it essentially skipped a whole layer. No enclosure/heating chamber btw. It was always the same height for that model, but then a smaller model like a benchie would have no issues on that height. I guess because the filament was warmer due to the smaller loops, so more mendible or less expanded somehow, idk.
I dried my filament so it stopped making bubbles and ran some filament specific calibration and also I changed the extrusion to be a bit lower. Then the issue was gone.
The fact it happened at the same z location twice is telling.
Try a slim vase-mode print that reaches past that height and see if it happens again.