Avoid fillets and use chamfers if at all possible. Fillets will often call for printing supports or just look bad. But the common 45 degree chamfer will be easily printed and look better when done.
The corner is laying down. The would be no supports in either case, and the fillet avoids hard turns while the chamfer still has two (less sharp) angles.
Like 99% of things in 3D printing, “Xs are to be preferred over Ys” is an entirely circumstantial statement that is never going to be true all of the time.
Avoid fillets and use chamfers if at all possible. Fillets will often call for printing supports or just look bad. But the common 45 degree chamfer will be easily printed and look better when done.
Chamfers are to be preferred over fillets.
The corner is laying down. The would be no supports in either case, and the fillet avoids hard turns while the chamfer still has two (less sharp) angles.
Like 99% of things in 3D printing, “Xs are to be preferred over Ys” is an entirely circumstantial statement that is never going to be true all of the time.
It depends on the orientation you print in.