• ryathal@sh.itjust.worksEnglish
      9·
      4 days ago

      Which part? The ruler that can’t exist or the part where finished lumber is smaller than the listed size?

      • celeste@kbin.earth
        15·
        3 days ago

        The thought of reaching into my toolbox and pulling out a measuring tape that’s labeled wrong without knowing it. He did a good job with this comic. That thought sucks so bad.

          • lunarul@lemmy.worldEnglish
            3·
            3 days ago

            As a European, it took me a while to realize what’s wrong with that. Even though I’ve been living in the US for almost 14 years now.

          • stelelor@lemmy.caEnglish
            1·
            3 days ago

            Oh yeah, we use these “decimal feet” rulers at my job, for surveying. Nobody bothered to tell me ahead of time, so my first few days out in the field were pretty much a complete waste. I still maintain they are an abomination, the worst of both systems.

            • lunarul@lemmy.worldEnglish
              2·
              3 days ago

              If it’s used for surveying, aren’t those survey feet? (a survey foot is 1.000002 US customary feet). Dividing a survey foot by 12 would not be technically an inch, even though it’s only a couple millionths off.